I’d be greatful if someone could push me in the right direction. I’ve tried various options, also updating with Mission Planner under Windows and with Qgroundcontrol in linux, but all fails. The firmware (arducopter_with_bl.hex) file is the latest from the repository. This program is Free Software and has ABSOLUTELY NO WARRANTYĭfu-util: A valid DFU suffix will be required in a future dfu-util release!!!ĭetermining device status: state = dfuERROR, status = 10ĭetermining device status: state = dfuIDLE, status = 0ĭownloading to address = 0x08000000, size = 2760652ĭfu-util: Last page at 0x082a1fcb is not writeable ![]() Sudo dfu-util -d 0483:df11 -c 1 -i 0 -a 0 -D arducopter_with_bl.hex -s 0x08000000Ĭopyright 2005-2009 Weston Schmidt, Harald Welte and OpenMoko Inc.Ĭopyright 2010-2016 Tormod Volden and Stefan Schmidt ago I tried the driver fixer and it doesnt detect the board :/ What should happen when I put it into bootloader mode Still isnt recognised by anything. I can flash the newest ombibusF4SD firmware in Betaflight (meaning hardware probably is OK), but using dfu-utils I consistenly get the following output and error: Run the impulserc driver fixer, if that doesnt put it in bootloader mode.Try holding down the boot button on the FC while you plug it into the computer. ![]() Trying to flash my newly received Omnibus F4 Pro (purchased directly from Airbot) fails.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |